På engelska, men jag hoppas det duger. [img]
http://new.hondaklubben.com/forum/style ... humbup.gif[/img]
ok, use the 2 pin blue connecter seen in the pics, its behind the ashtray so just take the center consol out and you should see it.
use a paper clip or wire to complete the cirucit. make sure the car is on "A/C" ...engine should NOT be running. just the normal, were the air, radio, etc works.
easiest way to understand the lights is this: short blinks equal 1, and long blinks equal 10. So for example, Blink, Blink, Blink, BBBLLLIIINNNNKKKKK. This would equal 3 smal blinks and a long blink. So you have 3 plus 10= 13. understand? Or 2 long blinks and a 2 short blinks would be 10+10+2=22.
0 Engine Control Module (ECM)
1 Heated Oxygen Sensor (HO2S)
3 Manifold Absolute Pressure (MAP SENSOR)
5 Same as above
4 Crankshaft Position (CKP SENSOR)
6 Engine Coolant Temperature (ECT SENSOR)
7 Throttle Position (TP SENSOR)
8 Top Dead Center Position (TDC SENSOR)
9 No. 1 Cylinder Position (CYP SENSOR)
10 Intake Air Temperature (IAT SENSOR)
12 Exhaust Gas Recirculation (EGR VALVE LIFT SENSOR)
13 Barometric Pressure (BARO SENSOR)
14 Idle Air Control (IAC VALVE)
15 Ignition Output Signal
16 Fuel Injector
17 Vehicule Speed Sensor (VSS)
20 Electric Load Detector (ELD)
21 Variable Valve Timing & Valve Lift Electronic Control (VTEC) Solenoid Valve
22 Variable Valve Timing & Valve Lift Electronic Control (VTEC) Pressure Switch
23 Knock Sensor (KS)
41 Heated Oxygen Sensor (HO2S) Heater
43 Fuel Supply System
