Få bort instrumentbräda i S2000

[Matte J]

Tja!

Om det är fel forumsdel så flytta gärna..

Min fråga är hur man får ur instrumentbrädan på en S2000?
Komplicerat? Hur är det med airbagen som sitterpå passagerarsidan, måste den bort?

O sen också till dom som har sett hur det ser ut under brädan, finns de nån plats alls på kanterna?
funderar på att försöka få i små högtalare direkt i instrumentbrädan.

Tack till er som vet!!

MvH Mathias

[Pirro]

www.s2ki.com regga dig där å sök, du kommer få mer info där om allt vad som gäller s2k än va du nånsin kan få här...

[Forenademotor.se]

SRS components are located in this area. Review the SRS component locations, precautions and procedures before performing repairs or service.
NOTE:
When prying with a flat- tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts to prevent damage.
An assistant is helpful when removing and installing the dashboard.
Take care not to scratch the dashboard, body and other related parts.
Put on gloves to protect your hands.
If equipped, make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
Disconnect the negative cable from the battery.
Remove these items:
Radio panel
Audio unit
Steering column
Passenger's dashboard lower cover
Front console cover, both sides
Passenger's airbag assembly
Kick panel, both sides
Front pillar trim, both sides
RHD: Remove the ECU (A) from the passenger's kick panel portion.
Disconnect the shaded connectors.
From outside both doors, remove the caps (A), then remove the bolts (B), ©, (D) and screws (E), and lift up on the dashboard (F) to release it from the guide pins (G). Take care not to scratch the center console and shift knob.
NOTE: LHD is shown, RHD is symmetrical.
Carefully remove the dashboard.
Install in the reverse order of removal, and note these items:
Make sure the dashboard fits onto the guide pins correctly.
Before tightening the bolts, make sure the dashboard wire harness and steering hanger beam wire harness are not pinched.
Make sure the connectors are plugged in properly.
If equipped, enter the anti-theft code for the radio, then enter the customer's radio station presets.

From outside both doors, remove the caps (A), then remove the bolts (B), ©, (D) and screws (E), and lift up on the dashboard (F) to release it from the guide pins (G). Take care not to scratch the center console and shift knob.
NOTE: LHD is shown, RHD is symmetrical.
Fastener Locations


Carefully remove the dashboard.
Install in the reverse order of removal, and note these items:
Make sure the dashboard fits onto the guide pins correctly.
Before tightening the bolts, make sure the dashboard wire harness and steering hanger beam wire harness are not pinched.
Make sure the connectors are plugged in properly.
If equipped, enter the anti-theft code for the radio, then enter the customer's radio station presets.

[Matte J]

Tackar så mycket! Nån som vet hur mycket jobb detta egentligen innebär? Kikat runt på SK2iforums o det låter som ett rent helvete att få bort den här!

Kanske nån som sitter inne med en bra översättning också

MvH Mathias